Table of Contents
Advertisement
During the using, if the blade always stopped please operate as follows
The branches is too rough, please choose branches below 8mm.
The blade cutting worsen: blade is worn the gap between the blade is too
big which reduce the cutting power.
The use of handle(SLP600D only)
To reduce fatigue when trimming hedges, the handle can
be swivelled through 90 to the left or right.
Process as follows:
1. Free the handle by pulling the locking lever.
2. Turn the handle until the locking lever clicks into place.
3.When the handle is locked in its new position, you can begin working.
CAUTION
Operation
1. While trimming, you should go forward along trimmed way. Going
back is not allowed.
2. Make sure the machine is used in normal condition away from the rock,
wire, hard wood, plastic.
3. Never use this machine for branches above 8mm.
IMPORTANT
Don't use for trimming when the handle is pulled.
OWNER'S MANUAL OF SL700D/SLP600D
14
Locking lever
Advertisement
Table of Contents
