How To Connect To The Specific Host Pc Automatically - NComputing PC Expanion L100 User Manual

7. How to connect to the specific host PC
automatically
How to configure the PC Expanion.
1
Click the <Setup> button in the startup screen on the PC Expanion.
2 Select the 'TS Options' tab, select 'TS 2' or 'TS 3', click the <Enable-
Disable> button and click the <Edit> button. To connect to a
specified host computer automatically, there must be one host
computer on the <Connection to> list of the PC Expanion initial
screen. If 'Autodetection' is selected in the 'TS Options' screen,
select 'Autodetection', click the <Enable-Disable> button to
unselect the option, and select either 'TS 2' or 'TS 3'.
8-16
Type the address that you want to connect to the host PC in the
'Terminal Server network address' column. Then select the
'Autoconnection Enable' option. Refer to '3. How to check the IP
address setting of host Computer' in Part 8. regarding the IP
address of specific host PC. Click the <OK> button. Then click the
<Save> button. The setup procedure is finished.
4
When the PC Expanion is rebooted, the PC Expanion attempts to
connect to the specific host PC after a few seconds. If the PC
Expanion is connected to the host PC, please check the IP address
of the specific host PC in the setup.
How to set up under the NCT-2000-XP console
1 <Start> ▶ <All Programs> ▶
<NCT-2000-XP> ▶ Select
<NCT-2000-XP Console> in
order to run the NCT-2000-XP
program. Go to the <Hardware
Settings (Local/LAN)> ▶ Select
<UTMA/UTSA Device> and then
select the specific PC Expanion
in the "UTMA/UTSA list" and
double-click it.