Table of Contents
Advertisement
M300 - Setup
4.1.5 Set offset (set local time)
This option lets you adjust the M300 to display local time*. You
only need to do this once, unless operating the unit in a new
time zone. (* By default the M300 displays GPS time. The M300
will perform all functions accurately without adjusting the offset
to display your local time.)
Note: If you attempt to change the time offset before all GPS data are
obtained, the screen displays 'no GPS' and the antenna icon flashes until all
GPS data are received.
Access this option
If necessary, press and hold
setup. Press
above.
To set local time
1) Press
to start editing (the screen now appears as shown
below). The current time value flashes. The date is displayed
to ensure that adjustments are made in the correct direction.
2) Press
repeatedly to set time display forward (press and
hold
to set time display forward quickly), or press
repeatedly to set time display backward (press and hold
set time display backward quickly).
3) Press
to stop editing.
4) Press
to go to the next option, or hold
1-14
repeatedly until the screen appears as shown
current time
PM
M300
SYSTEM
to turn the power on and enter
current date
SYSTEM
NAVMAN
SET
SET
to exit setup.
to
Advertisement
Table of Contents
