Navman M300 Quick Start Manual

NAVMAN
M300 — Settings
Setting options
Press and hold to enter setup
Press repeatedly to step through the setting options.
Press both buttons together ( ) to start or stop editing
a setting option.
While editing, press or repeatedly to step through selectable states,
or increase/decrease values. Press and hold the appropriate button to
increase/decrease values quickly.
Set (12hr)
lets you set 12hr or 24hr time format
Set (31-12)
lets you set dd-mm or mm-dd date format
Beep
When beep is «ON» a beep will sound when the buttons are
pushed.
Set units (knots)
lets you set speed units to «knots», «km/h» or «mph»
Distance is displayed in units corresponding to the speed units, i.e. if you
choose «knots» for speed units, then distance is displayed in nautical
miles.
Set offset
lets you adjust the M300 to display local time
The date is displayed to ensure that time adjustments are made in the
correct direction, i.e. both correct time and correct date should be
displayed. GPS signals must be obtained to set local time.
Press and hold to leave setup
NAVMAN
M300 — Settings
Use the settings
settings editing details
accept
edit set 12hr
set (12hr) set (12hr)
set 24hr
edit accept
set 31-12
set (31-12) set (31-12)
set 12-31
edit beep ON accept
beep beep
beep OFF
set units (knots)
edit accept
set units (knots) set units (knots) set units (km/h)
set units (mph)
� �
edit accept
set offset time (date)
KEY
= press this button
= press this button
= press both buttons together
NAVMAN
M300 — Modes
Normal operating modes
Press to start normal operation
Press repeatedly to step through the modes (hold to
cycle automatically through modes).
Speed
shows session distance and current speed
Speed (AVG)
shows session distance and average speed
Speed (MAX)
shows session distance and maximum speed
Odometer mode
shows total distance from last odometer reset
Heading mode
shows current heading in degrees from true North
Clock
shows the current time and date
(You may need to adjust the settings to display your local time.)
Timer
shows session and lap times
The timer starts automatically whenever you start moving and stops
whenever you stop moving.
Timer Recall
lets you recall stored lap data. Repeatedly pressing recalls
lap data starting from the last stored lap, then lap 1, 2, 3 etc.
Press and hold to shut down the M300
NAVMAN
M300 — Modes
Use the modes
modes operating details
store current lap data
Speed
clear all session data*
�
store current lap data
Speed (AVG)
AVG clear all session data*
�
store current lap data
MAX Speed (MAX)
clear max speed only
�
store current lap data
2
Odometer
8 7 clear odometer only
3
�
N Heading store current lap data
S
store current lap data
Clock
clear all session data*
�
store current lap data
Timer
clear all session data*
�
recall lap data
RCL Timer recall
restart recall from lap 1
(*does not clear odometer)
KEY
= press this button
= press this button
= press both buttons together
= press and hold both buttons together
*
QUICK START GUIDE