JVC KW-V40BT Instruction Manual page 45

CONNECTION/INSTALLATION CONNECTION/INSTALLATION

CAUTION
Install this unit in the console of your vehicle.
Do not touch the metal part of this unit during and
shortly after the use of the unit. Metal parts such as
the heat sink and enclosure become hot.
Supplied accessories for installation
1 Wiring harness x 1
2 Trim plate x 1
3 Extension wire x 1
4 Extraction keys x 2
5 Microphone x 1 *
* Only for KW-V40BT/KW-V20BT.
Installation procedure
1
To prevent a short circuit, remove the key
from the ignition and disconnect the
battery.
2
Make the proper input and output wire
connections for each unit.
3
Connect the speaker wires of the wiring
harness.
4
Take Connector B on the wiring harness
and connect it to the speaker connector in
your vehicle.
5
Take Connector A on the wiring harness
and connect it to the external power
connector in your vehicle.
6
Connect the wiring harness connector to
the unit.
7
Install the unit in your car.
8
·
Reconnect the battery.
9
Press the reset button.
10
Configure <Initial Settings>. (Page 4)
·
ENGLISH 45