US Robotics 221 Installation Manual page 10

I am unable to establish a wireless connection with my 22 Mbps Wireless
PCI Adapter.
Possible Solution:
Verify that the 22 Mbps Wireless PCI Adapter is properly installed. Make sure that the antenna of
the 22 Mbps Wireless PCI Adapter is firmly connected to the antenna port of the PCI Adapter. If
you continue to experience problems, uninstall the 22 Mbps Wireless PCI Adapter and repeat the
installation procedure.
Possible Solution:
If you are attempting a peer-to-peer connection, verify that each wireless adapter is set to 802.11
ad hoc mode. If you are using a Wireless Access Point, verify that each wireless adapter is set to
Infrastructure mode.
My 22 Mbps Wireless PCI Adapter does not see my Wireless Access Point in
the list when I scan for it.
Possible Solution:
If you create a wireless connection with the 22 Mbps Wireless PCI Adapter but are experiencing
poor link quality, check the positioning of the 22 Mbps Wireless PCI Adapter. Long distances,
multiple floors, or steel or concrete walls can diminish the link quality. If possible, reposition the
22 Mbps Wireless PCI Adapter to reduce the effect of any of these obstacles. In addition, check
any physical connections between the Wireless Access Point and your modem, router, hub, LAN,
or switch.
I accidentally clicked Cancel during the software installation procedure for
the 22 Mbps Wireless PCI Adapter.
Possible Solution:
Remove and reinsert the Installation CD-ROM into your CD-ROM drive. Repeat the software
installation procedure.
The software installation procedure did not begin when I inserted the
Installation CD-ROM.
Possible Solution:
Some programs may keep the autolaunch feature of the Installation CD-ROM from beginning.
Close any open applications and reinsert the Installation CD-ROM. If the Installation CD-ROM
interface does not run automatically, click Windows Start and then click Run. In the "Run" dialog
box, type D:\setup.exe. If your CD-ROM drive uses a different letter, type that letter in place of
"D."
I received a message that my 22 Mbps Wireless Access Point or my
computer shares an IP address with another computer on the wireless
network.
Possible Solution:
Each computer and 22 Mbps Wireless Access Point on the wireless network must have a different
IP address. Refer to your computer's documentation to see how to change the IP address on your
computer.
6