Mechanical Instructions - Philips 202P70/00 Service Manual

0. General
To be able to perform measurements and repairs on the "circuit
boards", these unit should placed in the service position first.
1. Remove the rear cover in Fig. 1 and Fig. 5.
Fig.1
-Remove 4 screws as shown
-Remove pedestal as shown Fig.1
-Remove 2 clips as shown Fig.2
-Remove 2 screws as shown Fig.3
-Remove back cover as shown Fig.4
-Remove 21 screws and remove
-Remove 2 screws as shown Fig.5
2. Video panel
-Disconnect the wire between metal shield of video panel and
CRT neck as shown in Fig. 6.
-Disconnect the CRT grounding from Video panel.
-Remove and grounding wire in Fig. 6.
3. Main board connector in Fig. 7.
-Disconnect york wire
-Disconnect rotation connector
-Disconnect control board connector
-Remove Screw for fixed I/F cable
-Remove signal connector
-Remove degaussing wire connector
Screw Screw Pedestal ass'y
Fig. 1
Clip Press down
Fig. 2

Mechanical Instructions

Shied bottom assy as shown Fig.4
Screw
Screw
202P7 CRT
Go to cover page
Screws
Fig. 3
Fig. 4
Fig. 5
Fig. 6
CRT grounding wire Video Panel
9