DIP Switches
Note
You must reset the CVS-1450 device in order for the setting change to occur.
© National Instruments Corporation
Figure 3-2. ACT/LINK and 100 Mbps LEDs
This section describes the SAFE MODE, IP RESET, NO APP, and
USER 1 DIP switches on the CVS-1450 device.
To enable a DIP switch, move it to the ON (left) position and then reset the
CVS-1450 device by pressing the RESET button for at least two seconds.
Chapter 3
3-3
LEDs, DIP Switches, and Connectors
NI 1454
Compact Vision System
NI CVS-1450 Series User Manual