Disassembly - Pioneer PRV-LX10 Service Manual

1

7.1.16 DISASSEMBLY

Note 1 : Do NOT look directly into the pickup lens. The laser beam may cause eye injury.
Note 2 : When disassembling, be careful not to injure yourself with a burr, etc. Place the unit on a flat, level surface to
A
perform servicing.
Note 3 : Even if the unit shown in the photos and illustrations in this manual may differ from your product, the procedures
described here are common.
1
Bonnet Assy
1
Remove the four screws.
1
-a
B
1
-c
C
2
Remove the fifteen screws.
3
Remove the bonnet Assy.
2
-d
2
D ×2
-a
2
×3
E
Note:
When attaching the bonnet Assy, tighten the screws in the
following order:
1-a, 1-b, 2-a to 2-g, 1-c, then 1-d.
F
158
1
2
Rear view
-c
2
-e
×3
×2
2
3
-b
Bonnet Assy
-f
2
×2
2
3
2
Tray panel Section
~ Remove the bonnet Assy. (See step ¥)
1
1 Press the STANDBY/ON button to turn on the power.
-b
2 Press the two 0 EJECT buttons to open the two trays.
3
Remove the two tray panel Section.
4 Press the two 0 EJECT buttons to close the two trays.
5
Press the STANDBY/ON button to turn off the power.
1
-d
1 5
3
2
4
Tray panel Section
How to open the tray when the power cannot be on
-g
When the product cannot eject tray due to power failure or any
2
×2
other reasons, use a long thin pole and push the emergency
eject hole under the tray panel to eject.
PRV-LX10
3
4
2 4
2 4
3
2
4
Tray panel Section
Tray panel
Long thin pole Emergency eject hole
4