Step 4 Auto Speaker Setup; Process For Auto Speaker Setup - Panasonic SA-HR50 Operating Instructions Manual

Auto speaker setup
Auto speaker setup allows you to achieve a satisfactory listening environment easily with the use of the supplied calibration
microphone as a detector of sound signals. The unit will first perform automatic speaker detection, then checks and adjusts the
following settings.
DETECTION
DISTANCE
SIZE
FREQUENCY
LEVEL
Loud test tones are output from the speakers during setup, so keep children out of the room.
Before setup
• Conduct the auto speaker setup in a quiet environment. A noisy background will give unsatisfactory results.
• Put the subwoofer in position, switch it on, and sets its volume to the level you would normally use.

Process for auto speaker setup


Turn on the unit.

Connect the calibration
microphone to the [SETUP
MIC] jack on the front
panel.

Placing of calibration
microphone.
10
10 10
SA-HR50 (RQTV0259-E).indb 10
• Checks which speakers you have connected. For manual setup, "Speaker size",
➡ page 12.
• Checks the distance of each speaker from the listening position and adjusts the
timing of each channel. For manual setup, "Distance", ➡ page 12.
• Calibrates based on small speaker configuration.
• Sets the appropriate low frequency crossover for each channel according to the
speaker size. For manual setup, "Filter", ➡ page 12.
• The setting is based on the speaker bass reproduction range.
Also checks on "Level" setting to adjust for each speaker.
•
• Makes any further corrections to the volume of each speaker and also to the
frequency response.
Press .
• The standby indicator goes off when you turn on the unit.
Note
The calibration microphone is sensitive
to heat. Keep it away from direct sunlight
and do not place it on top of the unit.
Calibration microphone
• Place on a flat surface at the seating area.
• Set calibration microphone position at your
ear height.
• Use a tripod for best results.
RETURN
(included)
MENU TUNE
SETUP ENTER
SETUP MIC
8/24/2007 10:10:16 AM