The Controls Of Your Wine Cooler; Setting The Temperature; Function Instruction - Silhouette DWC153BLSST Owner's Manual

The Controls of your
Wine Cooler
1.
Indicator light illuminates to signify the
cooling mode is currently in operation.
2. ' ' Button
To control this appliance turn ON/OFF
( press and hold this buttons for
approximately 3 seconds).
3. ' ' Button
To control the inner light turn ON/OFF.
(If you press this button, the inner
light is not controled by extrusion-board
of lamp swith, and keep lighting.)
4. °C / °F
Adjacent indicator light denotes which
scale of temperature is displayed.
Setting the
Temperature
When you plug in your wine
cooler for the first time,
the temperatures will auto-
matically be set to 54°F
(12°C) in the upper zone and
to 45°F(7°C) in the lower zone,
and will be displayed in the
Fahrenheit scale (°F)
Function
instructions
NOTE !
If put in too more bottles of wine at
one time or the door is not been
closed tightly,then there may show
signal "HI"at the diapaly panel.This
is the normal phenomenon,please
wait for a while after close the door
"HI" will disappear.
It is normal that the the cabinet shows
"HI" or "LO" between times, If it occurs
frequently or last for a long time, you
can get power off then restart to solve
it. If the problem occurs once again
after restart, Please contract the after-
sale service for help.
Operating Instructions
5. ' ' Window
For viewing the temperature
of the upper zone.
6. ' ' Window
For viewing the temperature
of the lower zone.
• To switch the display
between the Fahrenheit (°F)
and Celsius (°C) scale,
depress the and
control buttons simultaneo-
usly for approximately
five(5) seconds.
• The temperature range can
be set as low as 39°F (4°C)
or as high as 64°F (18°C) to
• • Temperature Memory Function Temperature Memory Function
In the event of a power interruption, wine cooler can remember the
previous temperature settings, and when the power is recovery,the
cabinet temperature will go back the same setting temperature as
power off.
• • Door Close Reminding Alarm Function Door Close Reminding Alarm Function
When you forget close the door or the door is not closed completely,
the buzzer alarm after 5 minutes. Please close the door completely
and advoid the cold energy was lost.
• • Temperature Alarm Function Temperature Alarm Function
If inner temperature is higher than 74°F(23°C), The "HI" is shown in
display panel, and the buzzer alarm after one hour continuously. It
inform that the inner temperature is too high,please check the reason.
If inner temperature is lower than
display panel,and the buzzer alarm at the same time.
6
° °
°
°
6
' Button
7. '
Used to set the temperature in
the upper zone (see 'Setting the
Temperature' below).
' Button
'
Used to set the temperature in
the lower zone (see 'Setting the
Temperature' below).
suit your specific storage
requirements. Each depres-
sion of the or
ton will allow you adjust the
temperature in 1° degree
increments within the afore-
mentioned range.
1°F (1°C), The "LO" is shown in
7
but-