Door Swing Reversal - Silhouette DWC153BLSST Owner's Manual

Installation Instructions - Door Swing Reversal
1 Bottom hinge (Right)
2 Screws
3 Door axis
4 Screws
5 Extrusion-board of the lamp swicth
6 Top hinge (Right)
1. Open the door 90 degrees, take out the 2 screws from the lower door axis (3), remove the door refer
to Fig.1A, now pull out the door and door axis (Fig. 1A).
2. Put the door safety and take out the decorative nail (7) from the top of the door frame, unscrew 2
screws (4) at the bottom and remove the Extrusion-board of the lamp switch (5), then install (5) at top
of the door frame, please use spare decorative nail to block the hole at the top of the door frame.
(Fig. 1A/1B)
3. Take out 3 screws (8) from top hinge (right) (6) and remove the right top hinge. (Fig. 1C)
4. Remove decorative nail (10) from the left top of cabinet and install spare top hinge (Left) (9) at left top
of cabinet with 3 screws. (Fig. 1D)
5. According to the above procedure, install spare lower hinge (left) (11) onto left lower cabinet. (Fig.1E)
6. The door revolves 180 degrees, install the door with the same way it was removed and fix it with the
door alightment.
7. Block the hole at the right top of cabinet with spare decorative nail.
Fig 1A
Fig 1C
Fig 1E
Fig 1B
Fig 1D
7 Decorative nail
8 Screws
9 Top hinge (Left)
10 Bottom hinge (Left)
11 Decorative nail
21