National Instruments NI USB-6008 User Manual page 11

Setting Up the NI USB-6008/6009 Device
1 Terminal Number Labels (Use Both Together)
2 Digital I/O Label
© National Instruments Corporation
Complete the following steps to set up the NI USB-6008/6009:
1. Install combicon screw terminal blocks by inserting them into the
combicon jacks.
2. Figure 5 illustrates the signal labels that ship in the NI USB-6008/6009
kit. You can apply the signal labels to the screw terminal blocks for
easy signal identification.
1
ANALOG
2
3. Refer to Table 4 and Figures 5 and 6 for signal label orientation and
affix the provided signal labels to the screw terminal blocks. Until the
signal labels are applied, you can insert the screw terminal blocks into
either of the combicon jacks.
DIGITAL
3 Single-Ended Signal Name Label (Use Either)
4 Differential Signal Name Label (Use Either)
Figure 5. NI USB-6008/6009 Signal Labels
11 NI USB-6008/6009 User Guide and Specifications
3
4