Operation - Swisher ST60022Q Owner's Manual

•
Fill engine crankcase with oil. A bottle has been provided with this unit. DO
NOT OVERFILL.
•
Fill the engine fuel tank with gasoline. GASOLINE SHOULD BE ADDED
OUTSIDE IN A WELL-VENTILATED AREA.
•
Check to ensure string has been installed properly. A diagram is provided
just above the wheel for proper installation.
Important! To ensure proper operation, clean the engine and trimmer
regularly. See page for details.
To start the trimmer:
•
Remove any built up debris from engine.
•
Pull control bail against the handle and hold.
•
Push primer button on engine as directed.
•
Pull back sharply on recoil starter handle.
•
Begin trimming.
Important! For safest operation, make sure debris is directed away from you and others.
Important! 12 Volt Units. For optimum battery performance, you should run engine for at least 15
minutes after each start to keep battery charged
To stop the trimmer:
•
Release the control bail. Engine will stop immediately.
•
Do not lift the trimmer head when trimming. Let the head rest lightly touching
the ground.
•
Keep an eye on the length of the trimmer strings. As the strings get shorter
they become less effective at cutting and will take longer to trim properly.
Replace the string as necessary. (See installing string)
•
Do not trim wet grass.
•
Use caution when trimming slopes.
•
Use the proper length of string. Using a string too long for the unit will cause
stalling and unacceptable operation.
Preparing Unit For First Use

Operation

Trimming Hints
7