Features Of Your Hair Dryer - Sunbeam HD3004 Instruction Manual

Features of Your Hair dryer

Air Outlet
5
This dryer is equipped with an appliance leakage circuit interrupter (ALCI) for your
safety. This device is designed to make the appliance inoperable under some
Cord Retract
abnormal conditions (such as accidental immersion in water).
Button
After the appliance is plugged in, you must check your protective device as follows:
1. Press the "Reset" button on the ALCI device.
2. Press the "Test" button. The "Reset" button will pop out. This verifies that the
Air Intake
3. Press the "Reset" button once more to reactivate the safety device and use
Grill
TO CONFIRM THAT THE PROTECTIvE dEvICE IS OPERATINg.
Off/Low/
Medium/High
Switch The Hair Dryer has 3 settings to control air speed/heat levels.
To control air speed/heat level, toggle the switch to desired
setting.
With the control setting switch in the "OFF" position, plug
Retractable Cord push
the Dryer into a standard 110-125-volt AC outlet. Select speed
cord retract button and
(airflow) setting that is most appropriate to your needs and that
hold electrical plug as it
will deliver the best results.
retracts
When finished using your Dryer, move the control switch to the
"OFF" position and unplug the cord from the outlet.
Use your SUNBEAM® Hospitality Hair Dryer with care. Directing a high volume of
heat continuously to one area can overheat hair and scalp. When using a High
setting, hold the blower opening a few inches away from the hair, drying one
section at a time. Work layers of hair in quick strokes. Keep the dryer in motion until
drying and styling are complete.
Folding
Handle
Operating Instructions
protective device is working properly.
your appliance.
REPEAT THE AbOvE PROCEdURE bEFORE EACH USE
To Use Your dryer
Caution
6