Yamaha CS-50 Instruction Manual page 6

CS-50 LEG
ASSEMBLY
<
(.
(For CS-60
Leg
Assembly
Instructions, see page
4.)
1
.
Unlatch the top cover and open
it
most
of the way
so the half-round hinges
can
be
disengaged. Lift off
the cover
and
set
it
aside.
2.
Loosen the two wing-screws
wtiich secure the
retaining flap for the four
legs,
hinge the
flap
open,
and withdraw
the
legs.
NOTE: Two
legs are longer, and
two
are shorter.
THE
SHORTER LEGS ARE THE BACK
LEGS.
3.
Loosen
the wing-screw on each of the two
flaps
which
secure the
leg braces,
and remove
the braces.
Also,
remove
the
thumbscrew from
its
mounting
bracket
in the top cover.
NOTE:
The two
leg braces each have a
rounded end
and
a
flattened
end. One flattened end
has a
round
hole and one has
a slot;
THE SLOT
IDENTIF
IES
THE
RIGHT-HAND
BRACE.
4. Tilt the synthesizer over so
it rests
on
its
back
edge,
and screw the four
legs
into
their
recessed
mounting
plates (long
legs
on
the front edge, short
legs
on
the
back edge).
DO NOT TIGHTEN THE
FRONT
LEGS
AT
THIS TIME.
5.
Hold
the
left leg
brace
so
the opening
in
its
rounded
end can
be slipped over the
tip
of the
left
front
leg
(just
above the
foot).
After positioning the brace
around
the
leg,
slide
it
up about
three inches,
as
illustrated.
Then
position the other
end
of the brace
so that the hole
is
aligned with the recessed socket
on
the bottom, back edge of
the synthesizer.
NOTE:
If
the leg
brace hole cannot
be positioned
in
alignment with
the
mounting
socket,
it
will be
necessary to
move
the other
end
of the brace along
the
leg. Tilt
the brace outward
to relieve the torque
on
the
leg,
slide the
brace up
or
down
as
appropriate,
and
again align the
mounting
holes.
6.
When
the
left
brace
is
aligned above
the
mounting
socket,
insert the
thumbscrew
through the hole
in
the leg
brace,
and thread the
screw into the socket.
DO NOT TIGHTEN THE
THUMBSCREW AT
THIS TIME.
7.
Attach
the right leg brace to the
tip
of the
right
front
leg,
and
adjust
its
position along the
leg
so you can
move
the
flat,
slotted end
of
the brace beneath the
thumbscrew and
the
flat
end
of the
left
brace.
8.
Tighten the thumbscrew
to secure the
leg braces,
and
then tighten the two
front
legs.
2.3
^H^l
^^^