Product Elements; Auxiliary Handle - Bosch GBH 2-26 E Operating Instructions Manual

Product Elements

Please open the foldout page with the illustration of the
tool and leave it open while you read these operating
instructions.
The numbering of the machine elements refers to the
illustration of the machine on the graphic page.
1 Quick change keyless chuck (GBH 2-26 DFR)
2 SDS-plus quick change drill chuck
(GBH 2-26 DFR)
3 Tool holder (SDS-plus)
4 Dust protection cap
5 Locking sleeve
6 Quick change drill chuck locking ring
(GBH 2-26 DFR)
7 Right/Left rotation switch
(GBH 2-26 RE/DRE/DFR)
8 Locking button
9 On/Off switch with speed control function
10 Unlocking button
11 Operational mode selection switch
Auxiliary Handle (see Fig.
Operate the machine only with the auxiliary handle 14.
By rotating the auxiliary handle 14 to a comfortable po-
sition, a fatigue-free and therefore safe working posi-
tion can be achieved.
Loosen the auxiliary handle 14 in the counter clock-
wise direction and adjust the handle to the desired
working position. Ensure that the clamping band of the
auxiliary handle is located in the groove intended for it
in the housing.
Then retighten the auxiliary handle 14 by turning in the
clockwise direction.
1 619 929 632 • (04.02) T
3 OPERATING INSTRUCTIONS
)
A
English–3
12 Button on the auxiliary handle
13 Depth stop

14 Auxiliary handle

15 Screw for drill chuck*
16 Drill chuck*
17 SDS-plus adaptor for drill chuck*
18 Assembled drill chuck*
19 Drill chuck receptacle (GBH 2-26 DFR)
20 Front sleeve of the quick change keyless chuck
(GBH 2-26 DFR)
21 Holding ring of the quick change keyless chuck
(GBH 2-26 DFR)
22 Clamping screw of the dust extraction attach-
ment*
23 Depth stop of the dust extraction attachment*
24 Telescope tube of the dust extraction attachment*
25 Winged screw of the dust extraction attachment*
26 Guide tube of the dust extraction attachment*
27 Universal holder for screwdriver bits*
* Not all the accessories illustrated or described are in-
cluded in standard delivery.
Selecting Drill Chucks and Tools
For hammer drilling and chiselling, SDS-plus tools are
required that are inserted in a SDS-plus drill chuck.
For drilling in steel or wood, for screw driving and for
thread cutting, tools without SDS-plus are used (for
example, drills with cylindrical shafts). For these tools,
a quick change keyless or a ring gear drill chuck is re-
quired.
Do not use tools without SDS-plus for hammer
drilling or chiselling! Tools without SDS-plus and
their drill chucks are damaged by hammer drilling or
chiselling.
GBH 2-26 DFR: The SDS-plus quick change drill
chuck can be easily replaced with the keyless drill
chuck provided.