Troubleshooting - Firecraft Pellet-Q450 Assembly And Instruction Manual

Grill Operation: Troubleshooting
A
B
C
Troubleshooting (continued)
and allow it to cool while adhering to the procures in the Operating Your Grill section of this
manual. Next, clean the Firepot. Next, check to ensure Igniter is getting hot but NEVER touch
the Igniter. If Igniter is not getting hot, contact your dealer or FireCraft.
AccuTemp™ Digital Control displays "ER-3":
Power failure during grill operation. Check to ensure grill is plugged in and check for power-fail-
ures in your home. If grill is plugged in and there is no power failure in your home, contact your
dealer or FireCraft.
AccuTemp™ Digital Control displays "ER-4":
RTD temperature Probe short. Contact your dealer or FireCraft.
Grill will not turn on:
Check to ensure grill is plugged in and check for power-failures in your home. Next, replace the
AccuTemp™ Digital Control Fuse located on the rear side of the AccuTemp™ Digital Control. If
grill is plugged in, there is no power failure in your home, and you replaced the fuse, contact
your dealer or FireCraft.
Grill will not maintain set temperature:
Check to ensure the Pellet Hopper has sufficient pellets. Next, shut down the grill and allow it
to cool while adhering to the procures in the Operating Your Grill section of this manual.
Clean the Cooking Grates, Heat Diffuser Plate, Firepot and Grease Bucket. If error still occurs,
contact your dealer or FireCraft.
D
19
H H
G
E F
H H