Elettro CF BOOSTER 1700 Operating Instructions Manual page 5

INSTRUCTIONS FOR USE
WARNING: BEFORE ITS FIRST USE, THE BOOSTER SHOULD BE CHARGED AT LEAST FOR 48 HOURS
CONSECUTIVELY
Using for emergency starts.
1. Protect your eyes from any accidents.
2. Attach the red clamp + to the positive pole of the battery to be charged and the black clamp – to the earth of
the engine (car frame). Make sure that the two cables do not come into contact with fans, belts or other moving
parts.
3. When starting the engine stay away from the battery.
4. After getting the engine started, disconnect the black negative clamp first, then disconnect the red positive
clamp.
5. Replace the clamps in their special slots at the rear of the appliance immediately.
Warning! If the engine does not start within 20 seconds, do not insist. Let the internal battery of the
BOOSTER cool down for at least 3 minutes, before trying to start the engine again. Strictly observe this
rule to prevent damage to the appliance.
Use as a power supply and a supplementary source of energy for vehicles.
To power the vehicle, connect the BOOSTER to the lighter socket, using the LESA 1 cable.
The BOOSTER is an essential instrument, taking the place of the car battery in all its applications. Many cars have
electronic components with a memory such as: alarm systems, on board computers, radio, telephone etc; when
replacing the battery these memories would be cancelled.
They can be saved by connecting BOOSTER to the lighter socket of the car using the LESA 1 cable, before
replacing the car battery.
Multipurpose source of supplementary energy.
The BOOSTER is a diversified source of portable energy for all 12V electrical appliances fitted with a plug for car
lighters. The electrical socket is protected up to 20A.
5