Unpacking & Moving - Viking VCWB301 Installation Manual

General Information
• Most of the unit's weight is at the top.
Extra care is needed when moving the unit
to prevent tipping.
• Do not remove protective film until unit is
in operating position.
• All four leveling legs must contact the floor
to support and stabilize the full weight.
• Do not drop unit.
• Remove exterior shipping materials prior
to moving unit into home, except door
latching device.
• Use two or more people to move and
install unit. Failure to follow this instruction
can result in back or other injury.
• To avoid personal injury, wear gloves when
performing any installation procedure and
wear eye protection when cutting metal
straps.
Moving Unit
Remove shipping brackets from skid by removing four
bolts (two on each side) with a 1/2" deep-well socket
wrench and a pair of pliers.
NOTE: Tilting unit is not required to remove
shipping brackets.
WARNING
TIP OVER HAZARD
Appliance is top heavy
and tips easily when
not completely
installed. Keep doors
closed until appliance
is completely installed
and secured per installation instructions.
Use two or more people to move and
install appliance. Failure to do so can
result in death or serious injury.
Unpacking Unit
1. Remove top and bottom strap.
2. Remove top cap.
3. Cut carton rear approximately 1/4" (0.6
cm) to 1" (2.5 cm) from right corner with a
utility knife extended 1/4" (0.6 cm).
4. Remove carton and exterior packaging.
Save cardboard shipping material to
protect floor surface when installing unit.
Remove anti-tip boards and kickplate from
rear of unit.
Slip appliance dolly between unit and skid. Remove
unit from skid. Only use dolly from the rear of the unit
to remove unit from skid. After the unit is removed
from the skid, a dolly can be used from either side or
back but NOT THE FRONT.
NOTE: Use excess packaging to protect decorative
trim; also, verify that leveling legs are up
(0" adjustment).
17