Black & Decker STARTHILFE BDV040 User Manual page 4

ENGLISH
Do not charge the appliance using the 12 Vdc connector
when the vehicle is occupied. Ensure the area is well
ventilated.
To reduce the risk of electric shock, disconnect the
appliance from any power source before attempting
maintenance or cleaning. Turning off controls without
disconnecting the appliance will not reduce this risk.
The 12 Vdc outlet is strictly for use as an accessory
outlet, the maximum output is 5A. Never insert a vehicle
cigarette lighter into the unit's 12 Vdc accessory outlet.
Make sure the appliance is disconnected from all
charging power sources before beginning the battery
boost procedure.
Never attempt to use the ac charger and dc charging
connection simultaneously.
The appliance will not start a vehicle with a flat battery.
The appliance will not function correctly if you have
other electrical faults on the vehicle.
This appliance is to be used only on vehicles with a DC
negative earth system.
Additional safety instructions for batteries and chargers
Batteries
Never attempt to open for any reason.
Do not expose the battery to water.
Do not store in locations where the temperature may
exceed 40 °C.
Charge only at ambient temperatures between 10 °C
and 40 °C.
Charge only using the chargers provided with the
appliance.
When disposing of batteries, follow the instructions
given in the section "Protecting the environment".
Under extreme conditions, battery leakage may occur.
When you notice liquid on the batteries, carefully wipe
the liquid off using a cloth. Avoid skin contact.
In case of skin or eye contact, follow the instructions
below.
Warning! The battery fluid is a diluted sulphuric acid and
may cause personal injury or damage to property. In case of
skin contact, immediately rinse with water. If redness, pain or
irritation occurs seek medical attention. In case of eye
contact, rinse immediately with clean water and seek
immediate medical attention.
Chargers
Your charger has been designed for a specific voltage.
Always check that the mains voltage corresponds to the
voltage on the rating plate.
Warning! Never attempt to replace the charger unit with a
regular mains plug.
4
Use your Black & Decker charger only to charge the battery
in the tool with which it was supplied. Other batteries could
burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
Have defective cords replaced immediately.
Do not expose the charger to water.
Do not open the charger.
Do not probe the charger.
The battery must be placed in a well ventilated area when
charging.
Symbols on your charger
Fail-safe isolating transformer. The mains supply
is electrically separated from the transformer
output.
The charger automatically shuts off if the
ambient temperature becomes too high. As a
consequence the charger will be inoperable. The
charging base must be disconnected from the
mains supply and taken to an authorised service
centre for repair.
The charging base is intended for indoor use
only.
Read the instruction manual before use.
Electrical safety
This tool is double insulated; therefore no earth
wire is required. Always check that the power
supply corresponds to the voltage on the rating
plate.
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
This appliance includes some or all of the following features:
1. Storage compartment
2. 12 Vdc accessory outlet
3. On/off button
4. Vehicle boost button
5. Recharge button
6. Area light button
7. 12 Vdc charging socket
8. Area light
9. Mains charging adaptor
10. 12 Vdc vehicle adaptor