Napoleon GDS28P Installation And Operating Instructions Manual page 44

44
SYMPTOM
Door Sticking
Main burner goes out; pilot
goes out.
GS28
SYMPTOM
Main burner goes out; pilot
stays on.
GDS28
SYMPTOM
Main burner goes out; pilot
goes out.
Main burner fl ame is a
blue, lazy, transparent
fl ame.
W415-0153 / B / 06.10.10
PROBLEM
Dirt / dust adheres to the hinges;
is heated and burns causing
sticking.
Thermocouple shorting or faulty.
PROBLEM
Venting is spilling.
PROBLEM
Vent re-circulating.
Blockage in vent.
Incorrect installation.
TEST SOLUTION
- Lift door from its hinges. Lubricate with high temp dry
graphite only. Replace.
- NOTE: Due to the high temperatures that the hinges
experience, wet lubricants such as oil and WD40 will
cause the hinge to seize and are therefore not suitable.
- Loosen and tighten thermocouple.
- Clean thermocouple and valve connection.
- Replace thermocouple.
TEST SOLUTION
- Test with spill switch bypassed.
- Check for vent blockage.
TEST SOLUTION
- Check joint seals and installation.
- Remove blockage. In really cold conditions, ice buildup
may occur on the terminal and should be removed as
required.
- Ensure vent confi guration is within prescribed venting
parameters