Electrical Connection; Water Connection - Buffalo GH187 User Instruction Manual

Electrical Connection:

The appliance must be earthed.
Check that the voltage on the rating plate of your appliance corresponds with your
electricity supply.
The boiler is supplied with a 13 amp plug. If replacing the plug, connect the terminals
as follows:
GREEN and YELLOW wire
BLUE wire
BROWN wire
For safety regulations the plug or means of disconnection must always be accessible.

Water Connection:

Connect the supplied inlet hose to the inlet connection point on the base of the appli-
ance and the other end to the mains cold water supply.
Overflow & Drainage
Due to the electronic function of the appliance it is highly unlikely that an overflow
would occur. The appliance is designed so that any overflow occurrence and conden-
sation is directly vented into the drip tray.
Note: There will be some steam emissions from the vent at the base of the appli-
ance during its initial fill stages. The steam emissions will lessen as the water volume
increases in the tank.
STEAM VENT
MAINS CABLE
FILTER HEAD
(FILTERED MODEL(S) ONLY)
GC719
FILTERED
MAINS WATER
CONNECTION
EARTH - E
NEUTRAL - N
LIVE - L
STEAM VENT
MAINS CABLE
GH187
UNFILTERED
MAINS WATER
CONNECTION