Electrical Wiring - Buffalo CU547 Instruction Manual

EN
Fault
Indicator light comes
on but water does not
reach temperature
The tap is leaking
(for GL346 series and
CU547 series)
Water not dispensing
(for HF150 series)

Electrical Wiring

This appliance is supplied with a 3 pin BS1363 plug and lead.
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency
disconnection being required they must be readily accessible.
Compliance
The WEEE logo on this product or its documentation indicates that the product must
not be disposed of as household waste. To help prevent possible harm to human
health and/or the environment, the product must be disposed of in an approved and
environmentally safe recycling process. For further information on how to dispose of
this product correctly, contact the product supplier, or the local authority responsible for
waste disposal in your area.
BUFFALO parts have undergone strict product testing in order to comply
with regulatory standards and specifications set by international,
independent, and federal authorities.
BUFFALO products have been approved to carry the following symbol:
All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic,
mechanical, photocopying, recording or otherwise, without the prior written permission of BUFFALO.
Every effort is made to ensure all details are correct at the time of going to press, however, BUFFALO reserve the right to
6
GL346-GL349_HF150-HF153_CU547-CU549_CJ549_ML_A5_v7_20230105.indb 6 GL346-GL349_HF150-HF153_CU547-CU549_CJ549_ML_A5_v7_20230105.indb 6
Probable Cause
Thermostat fault
The tap has become loose
Sensor not detecting the cup
change specifications without notice.
Solution
Consult a qualified technician
Tighten the tap handle
Not suited for glass cups, so ensure the cup
used is opaque
2023/1/5 16:41 2023/1/5 16:41