Tower Case - Micron ClientPro 766Xi System User's Manual

Micron ClientPro 766Xi/Xe User's Guide

Tower Case

Refer to the Figure on page 1-7. Use a #2 Phillips-head screwdriver or a 1/4"
hex driver.
1. It is not necessary to disconnect the cable connectors on the back
of the computer before opening the cover. However, note where
the cables connect to the back for future reference . (If you have
a video camera, a quick scan of the rear case is helpful).
2. Remove the screws from the back of the case cover. Keep these
screws together (they are a different size than the other screws
in your system) for they are not to be interchanged.
3. With flat palms placed on each side of the cover, pull the cover
back until the cover's front top lip clears the chassis channel
(about 3/4"). Grasp the top-rear of the cover and lift up in one
smooth motion until the cover clears the chassis.
To replace the cover, gently lower the top lip of the cover into the chassis
channel at an angle before lowering the rear into place. With the lip inserted
in the channel, push the rear of the cover forward to seat it flush and replace
the screws. Note the metal rail guides located inside the bottom of the cover
which must fit over the bottom metal case frame when the cover is replaced.
1-16 Micron Electronics, Inc.