McIntosh C1000C Owner's Manual page 30

Listen Processor
The C1000 Preamplifier has a Listen Processor Loop for
hooking up an external sound processor. The Listen Proces-
sor may be assigned to be active for only those Inputs de-
sired. To activate the Listen Proccessor Loop and assign
Inputs, perform the following steps:
Note: If the Listen Processor is set active for a given Input
and no Listen Processor is connected to the C1000P,
no sound will be heard when that Input is selected.
1. Press the SETUP Push-button twice to access the Setup
Preamp Mode unless the C1000C is already in the
Setup Preamp Mode.
2. Rotate the BALANCE (Menu) Control until the Alpha-
numeric Display indicates "LPROC NONE". Refer to
figure 40.
Figure 40
When there is just one Preamplifier (C1000P or C1000T)
connected to the C1000 Controller, proceed to step 3. If
both Preamplifiers (C1000P and C1000T) are connected to
the C1000 Controller, proceed to step 10.
3. Rotate the LISTEN (Select) Control until the word
PRESENT appears in the Display, "LPROC
PRESENT". Refer to figure 41.
Figure 41
4. Rotate the BALANCE (Menu) Control until the Alpha-
numeric Display indicates "LPROC TUN - -". Refer
to figure 42.
Figure 42
5. Rotate the LISTEN (Select) Control until the word ON
appears in the Display, "LPROC TUN ON". Refer
to figure 43.
Figure 43
6. Rotate the RECORD (Select) Control until the Title of
the next desired Input is displayed and then set the Lis-
ten Processor to On.
7. Rotate the LISTEN (Select) Control until the word ON
appears in right side of the Display.
30
8. Repeat steps 6 and 7 until all Inputs requiring the Listen
Processor have been set active.
9. Proceed to step 16.
10. Rotate the LISTEN (Select) Control to select which
Preamplifier will have an External Processor connected
to it. The choices are PREAMP (C1000P), TUBE
(C1000T) or BOTH (C1000P and C1000T) Preamplifi-
ers. Refer to figures 44a, 44b or 44c.
Figure 44a
Figure 44b
Figure 44c
11. Rotate the BALANCE (Menu) Control until the Alpha-
numeric Display indicates "LPROC TUN - -". Refer
to figure 42.
Note: The Inputs of the C1000T will have the number 2
after the Title; e.g. TUN2, CD2, DVD2,etc.
12. Rotate the LISTEN (Select) Control until the word ON
appears in the Display, "LPROC TUN ON". Refer to
figure 43.
13. Rotate the RECORD (Select) Control until the Title of
the next desired Input is displayed and then set the Lis-
ten Processor to On.
14. Rotate the LISTEN (Select) Control until the word ON
appears in right side of the Display.
15. Repeat steps 6 and 7 until all Inputs requiring the Listen
Processor have been set active.
16. If no other adjustments are to be made at this time,
press the SETUP Push-button to exit the Setup Preamp
Mode or proceed to the next desired Setup Preamp
Mode for adjustment.