Carrier 42NQV050M Service Manual page 92

No. Part name
‡
Compressor 1) Perform work of item 1 of
2) Extract refrigerant gas.
3) Remove the partition board.
4) Remove the sound-insulation material.
5) Remove terminal cover of the compressor, and
6) Remove pipe connected to the compressor with
7) Remove the fixing screw of the bottom plate
8) Remove the fixing screw of the bottom plate
9) Pull upward the refrigeration cycle.
10) Remove BOLT (3 pcs.) fixing the compressor
ˆ
Reactor 1) Perform work of item 1 of
2) Remove screws fixing the reactor.
Procedure
(ST1TØ4 × 8L 3 pcs.)
disconnect lead wire of the compressor from the
terminal.
a burner.
• Take care to keep the 4-way valve away from
naked flames. (Otherwise, it may malfunction.)
and heat exchanger. (ST1TØ4 × 8L 1 pc.)
and valve fixing plate. (ST1TØ4 × 8L 1 pc.)
to the bottom plate.
* Precautions when assembling the compressor.
Tighten the compressor bolts using a tighten-
ing torque of 4.9 N•m.
(ST1TØ4 × 8L 4 pcs.)
 ‚ ƒ „ …
and , , , .
‚ ƒ
, and .
– 91 –
Remarks
Partition board
Valve fixing plate
Compressor
Reactor