Confirmation Of Network Camera Operation - Panasonic KX-HCM280 Operating Instructions Manual

Operating Instructions

5.5 Confirmation of Network Camera Operation

This procedure checks the Network Camera operation. An IP address of the PC
has to be on the same network to be able to access a Network Camera. If Top
Page appears, the Network Camera has no defect.
1.
Push the FACTORY DEFAULT RESET button as illustrated on page 110. All
settings on the Network Camera will be set to default.
2.
Connect locally between the PC and the Network Camera like [Type 1] or
[Type 4] configuration type shown on page 18 and page 19.
3.
Follow the next steps distinguished by the operating system in the next table
to open TCP/IP Properties window.
Operating
System
Windows 95
Windows 98
Windows Me
Windows NT [Start] –> [Settings] –> [Control Panel] –> [Network] –>
Windows
2000
Windows XP [Start] (–> [Settings]) –> [Control Panel] –> [Network and
Note
When using Windows NT, Windows 2000 and Windows XP, log on as an
administrator to access TCP/IP Properties window.
128
TCP/IP Properties Table
[Start] –> [Settings] –> [Control Panel] –> [Network] –>
Select [TCP/IP] with adaptor in use –> [Properties] –>
[Specify an IP address]
[Protocols] tab –> [TCP/IP Protocol] –> [Properties] –>
Select [Adaptor] in use –> [Specify an IP address]
[Start] –> [Settings] –> [Control Panel] –> [Network and
Dial-up Connections] –> [Local Area Connection Icon] in
use –> [Properties] –> Select Internet Protocol [TCP/IP]
–> [Properties] –> [Use the following IP address]
Internet Connections] –> [Network Connections] –>
[Local Area Connection Icon] in use –> [Properties] –>
Select Internet Protocol [TCP/IP] –> [Properties] –> [Use
the following IP address]
Steps