When Using The "Viewnetcam.com" Service; Procedure To Register Information For The "Viewnetcam.com" Service - Panasonic WV-SW598 Operating Instructions Manual

17 Configuring the network settings [Network]

17.4.2 When using the "Viewnetcam.com" service

[Personal(Camera) URL]
The URL of the camera registered for "Viewnetcam.com".
[Your Account Link]
When the displayed URL is clicked, the registration window for the "Viewnetcam.com" service will be displayed
in a newly opened window.
Register the information in the registration window to enroll in the "Viewnetcam.com" service.
[Access interval]
Select the interval to access the "Viewnetcam.com" service server to check the IP address and the host name
from the following.
10min/ 20min/ 30min/ 40min/ 50min/ 1h
•
Default: 1h
[Global IP Address Notification Method]
Typically [Global IP Address Notification Method] should be set to "Normal".
If you cannot access the camera using the registered URL 30 minutes after registering with
"Viewnetcam.com", select "Advanced".
In this case, UPnP (®page 171) must be enabled for the camera and for the router.
•
Default: Normal
17.4.3 Procedure to register information for the
"Viewnetcam.com" service
1.
Select [Viewnetcam.com] for [DDNS] and click the [Set] button.
→
A URL is displayed in [Your Account Link].
If a URL is not displayed in [Your Account Link], confirm the camera's network settings and Internet
connection, then click [Set] again.
2.
Register the information for "Viewnetcam.com" by following the instructions of the wizard.
→
The registration window for "Viewnetcam.com" will be displayed in a newly opened window.
192 Operating Instructions