Advertisement
3. Refer to the inset drawing. If there is a plastic tie in the
Cage Nut (70) in the Right Handrail (88), remove the
plastic tie. Pull 15 cm (6 in.) of the two Wires (21) out of
the right Upright (11). Feed the Wires up into the Right
Handrail as shown. Using needlenose pliers, pull the
Wires out of the indicated hole in the Right Handrail.
Insert the bracket on the Right Handrail (88) into the right
Upright (11), with the lower end of the Right Handrail be-
side the Extension Leg (34). Loosely thread a Short
Handrail Bolt (89) with a Washer (39) into the upper end
of the Upright.
Attach the Left Handrail (1) as described above. Note:
There are no wires in the left Upright (11).
4. Attach the lower end of the Right Handrail (88) to the
Extension Leg (34) with a Handrail Bolt (91), a Handrail
Washer (92), and a Handrail Nut (93) as shown. Do not
tighten the Handrail Nut yet. Note: It may be necessary
to push on the lower end of the Handrail to align the hole
in the Handrail with the hole in the Extension Leg.
Attach the Left Handrail to the left Extension Leg (not
shown) as described above.
5. Place the Console Base (46) on the Handrails (88, 1)
(only the Right Handrail is shown). Pull out just enough
of the two Wires (21) to connect them to the receptacles
in the Console Base. Make a loop with the indicated
plastic tie and insert the end through the tie holder on the
bottom of the Console Base. Locate the Wire that has a
two-pin connector and a three-pin connector. Plug the
connectors into the matching receptacles in the Console
Base. If the connectors do not fit easily, rotate them
and then plug them in. Next, plug the other Wire into
the other receptacle on the Console Base. WARNING:
Do not connect or disconnect the Wires whilst the
treadmill power cord is plugged in. Securely tighten
the plastic tie to prevent the Wires from slipping. Cut off
the end of the plastic tie. Slide the Wire Cover (106) onto
the connectors so that they are completely covered.
See the inset drawing. Loop the included plastic tie
around the Wire Cover (106) so that the plastic tie is in
the two notches in the Wire Cover. Tighten the plastic tie
and cut off the end.
Refer to drawing 5b. Thread four Screws (79) into the
Handrails (88, 1) and the Console Base (46). Make sure
that the Wires (21) in the Right Handrail are clear of
the screw holes. After all four Screws have been
started, tighten the Screws until they are snug; do not
overtighten them.
3
1
88
11
88
70
21
Tie
34
11
4
88
34
93
92
91
5a
46
Tie
88
21
106
Tie
5b
21
88
46
79
6
HOW TO LOWER THE TREADMILL FOR USE
1. Hold the upper end of the treadmill with your right hand
as shown. Using your left thumb, press the storage latch
and hold it. Pivot the treadmill until the frame is past the
89
storage latch.
39
11
2. Hold the treadmill firmly with both hands, and lower the
treadmill to the floor. Do not drop the treadmill frame to
the floor. To decrease the possibility of injury, bend
your legs and keep your back straight.
106
1
79
Unlatched
Storage
Latch
11
Advertisement
