4
Raise the fusing unit release lever, close the front cover and
then close the side cover by pressing the round projections
near the side cover open button. The misfeed (
go out and the start (
DEVELOPER REQUIRED
When the developer replacement required (
should be replaced. DEVELOPER REPLACEMENT SHOULD ONLY BE DONE BY
AN AUTORIZED SHARP SERVICE TECHNICIAN. Contact your service centre as
soon as possible.
MAINTENANCE REQUIRED
When maintenance (
service technician is required. Contact your service centre as soon as possible.
SCAN HEAD LOCKING SWITCH
The scan head locking switch is under the original table. If the switch is locked (
the unit will not operate. Unlock the switch (
Grasp here and turn in
the direction of the arrow.
Lock
) indicator will light up.
) indicator lights up, service by an authorised SHARP
Unlock
) indicator will
) indicator lights up, the developer
) as shown below.
),
6
31