Control Your Tv - Orion Color CRT TV User Manual

2.

CONTROL YOUR TV

To use the TV, follow the instructions below.
1. Fit the batteries into the remote control.
2. Plug the TV into a power socket.
- The plug for connection to the grid power socket will power your TV.
- The TV can only be connected to 220-240V~ 50-60Hz alternate current.
- If the plug comes loose from the power cord, do not connect it to a power socket: you might be electrocuted.
3. Connect the external aerial or the cable aerial to the socket on the back of the TV.
4. Press ON/OFF key on the TV.
5. The light on the TV will turn on: the TV is in "Stand-By" mode.
2-1 MAIN POWER ON/OFF
When in "Stand-By" mode, press this button to switch on the TV.
Press again to go back to "Stand-By" mode.
To switch off the TV, press ON/OFF on the TV.
Notes:
- When in "Stand-By" mode, the TV can also be switched ON by pressing the "channels Up/Down" buttons on
the remote control or on the TV.
- The TV is provided with an automatic switch-off feature (Automatic Power OFF). When in "No Signal" mode,
the TV automatically goes to "Stand-By" mode after a few minutes.
- Every time the TV is switched on, TV mode is automatically selected; if an input signal is received by the
SCART plug, SCART AV mode is automatically selected.
2-2 TV/AV SELECTION
By repeatedly pressing the [TV/AV] key, you can select the desire input source as follows:
Note: 1. When input is SCART signal, TV automatically goes in SCT mode to receive SCART signal, even if
TV/AV button is not pressed.
2. SCT2 and front/side AV are parallel. Video priority given to AV input. If video is connected then there
will be no audio in SCT2 how ever picture can be seen.
3. It is recommended SCT2 and front AV input not to be connected at the same time.
2-3 MUTE
By pressing this key, sound output will be muted.
Press [MUTE] again, or Volume Up, and sound Volume will return.
2-4 DIRECT ACCESS TUNING
Using the numeric keys on Remote Control Unit. Programs can be selected directly.
2-5 SELECT TELETEXT MODE
Press [TTX] button on the remote control unit and enter to TELETEXT mode.
TTX
By this button, mode will be changed as:
The overview station page or the last page viewed (in case you already watched TELETEXT at this channel
previously) appears.
If you need to return to TV mode, press again the [TTX] button on the remote control.
2-6 QUICK VIEW
TV Mode: program will quick back to the previous program being watched.
AV Mode: Back to TV program.
2-7 PICTURE MENU
Press this button on the remote control unit and enter to PICTURE MENU.
Press again this button to remove it
GB
TV SCT1 RGB SCT2
TV Teletext
2
Y/C AV