Table of Contents
Advertisement
Operation
Figure 4-4 Removing grinding tools
2.
3.
4.5. Preparations for dry grinding
Warning!
Check that the splash guard is fitted.
1.
18
Slide the grinding tool diagonally from above down into
the appropriate guide slot on the tool holder - see Figure
4-2 on page 16. Then push the tool fully into the guide
slot.
Lock the grinding tool into the tool holder by giving
it a few light taps with a rubber hammer - see Figure
4-3 on page 17.
Connect a dust extractor to the machine. For dust extractor
models, see under the Suction System tab in the HTC
Product Catalogue.
HTC 420 VS
3.0
Advertisement
Table of Contents
