Table of Contents
Advertisement
• MODEL IDENTIFICATION
– Back Panel –
PART No.
Model
US model
Canadian model
SECTION 1
SERVICING NOTES
UNLEADED SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
: LEAD FREE MARK
Unleaded solder has the following characteristics.
• Unleaded solder melts at a temperature about 40 °C higher
than ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350 °C.
PART No.
Caution: The printed pattern (copper foil) may peel away if
2-514-880-0[]
2-514-880-1[]
• Strong viscosity
Unleaded solder is more viscou-s (sticky, less prone to flow)
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
• Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.
STR-DA2100ES
the lead free mark due to their particular size)
the heated tip is applied for too long, so be careful!
5
Advertisement
Table of Contents
