Sony NSR-S10 Installation Manual page 2

WARNING
To reduce the risk of fire or
electric shock, do not expose
this apparatus to rain or
moisture.
To avoid electrical shock, do not
open the cabinet. Refer
servicing to qualified personnel
only.
IMPORTANT NOTICE
This equipment is assigned a Model No. for
regulatory compliance certifications.
The number is indicated on the model
number label on your product along with
the rated voltage and current.
Ordering Model Name. and Type No.
Ordering
Information
Model NSR-S10/S20
1 HDD
Model NSR-S10/S20
0 HDD
WARNING
Use the AC power adapter provided with
this equipment as a power supply source.
Manufacture: Sony
Type No.: NSR-AC1
Any other power sources may result in
hazards such as a fire.
Disconnect device of this equipment is the
mains plug of the AC adapter.
The mains plug on this equipment must be
used to disconnect mains power. Please
ensure that the socket outlet is installed near
the equipment and shall be easily
accessible. In the event of abnormal
operations, disconnect the mains plug.
NOTICE
Use the power cord set approved by the
appropriate testing organization for the
specific countries where this unit is to be
used.
2
Model No. for
Certification
AVOM001
AVOM002
CAUTION for LAN port
For safety reason, do not connect the LAN
port to any network devices that might have
excessive voltage.
Installing battery (IR Remote
Commander)
A CR2025 type lithium battery is supplied
for IR Remote Commander.
To avoid risk of explosion, use the same
type of lithium battery.
CAUTION
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type recommended by the
manufacturer. Dispose of used battery
according to the manufacturer's
instructions.
Caution for System Developers
in the USA
Additional requirements may be necessary
when the product is used in access control
system applications.
For the customers in the USA
WARNING
This device complies with Part 15 of the
FCC Rules.
Operation is subject to the following two
conditions: (1) this device may not cause
harmful interference, and (2) this device
must accept any interference received,
including interference that may cause
undesired operation.
NOTE: This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment generates, uses
and can radiate radio frequency energy and,
if not installed and used in accordance with
the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that