Tiger PDR-A30U User Manual page 12

3
Boiling Water
6
Select [Keep Warm]
Press Temp.Set key.
■Keep Warm temperature
208
(approx.208°F)
176
(approx.176°F)
Each press of Temp.Set
temperature setting as shown.
Light
illuminates
You can change temperature setting during Boiling cycle
or Keep Warm.
Caution If the power cord comes off during the
temperature setting, the setting is not completed.
It will go back to default setting. (194)
■During the boiling cycle
Current water temperature
Flashing
Displays alternately
approximately every
10 seconds
※ Timing to start displaying remaining time will vary depending on
the amount of water and the water temperature.
※ Water temperature will be displayed by every 9°F. (If it is
approximately 208°F, it will display "208".)
7
Automatically set to warmer
■When boiling
■When water temperature
reaches setting temperature...
• Do not come in contact with the steam to
Caution
avoid being scalded.
• Do not open or close the lid with excessive
force and do not dispense hot water during
the boiling cycle or immediately after boiling.
Failure to do so may cause scalds due to hot
water splashing or steam being emitted.
11 11
. 194 .
(approx.194°F)
.158 .
(approx.158°F)
key changes different
Flashing
Remaining time until boiling
Flashing
Light
illuminates
Light
illuminates
turns o
Time table for Boiling and Cooling
Boiling from cold water
From boiling to reach 194
warmer temperature
From boiling to reach 176
warmer temperature
From boiling to reach 158
warmer temperature
※ Under these conditions: full water volume, the water temperature /
room temperature is 73°F, and voltage is normal rated voltage.
※ Guidelines for the time required to reach the 208 warmer temperature
are almost the same as those for boiling from cold water.
To re-boil during the Keep Warm cy-
cle. Press
Be sure the water level is above Refill water mark.
illuminates
Guidelines for the time required for re-boiling
when the water is at the full water level
Warmer temperature at 208, 194
Warmer temperature at 176
Warmer temperature at 158
※ Adding water or reattaching the power cord during Boiling cycle,
boiling time may extend.
■To reduce chlorine smell during Keep
Warm cycle.
Press the Re-Boil / Timer key twice.
Light
Press Re-Boil / Timer
until you reach your preferred option cycle.
Re-boil
Keep
warm
※ Be sure to check the display panel for your preferred cycle. It
uses both Re-Boil / Timer key and [Power-Saving Timer]
3.0L Type
Approx.
35 minutes
Approx.
45 minutes
Approx.
1 hour and
35 minutes
Approx.
3 hour and
0 minutes
key once.
Re-Boil/Timer
Flashing
Light
3.0L Type
Approx.5-10
minutes
Approx.12-14
minutes
Approx.16-18
minutes
Flashing
Flashing
key and scroll through the option
boil + 6 hour
dechlorinate timer
10 hour 9 hour
timer timer
4.0L Type
Approx.
45 minutes
Approx.
45 minutes
Approx.
1 hour and
40 minutes
Approx.
3 hour and
10 minutes
4.0L Type
Approx.5-11
minutes
Approx.14-16
minutes
Approx.20-22
minutes
7 hour
timer
8 hour
timer