Troubleshooting - NAD 116 Owner's Manual

TROUBLESHOOTING.

NO SOUND
Power AC lead unplugged or power not switched on.
Tape 1,2 Monitor selected.
Mute on.
Connector to power amp not fitted correctly.
Internal fuse blown.
NO SOUND ONE CHANNEL
Balance control not centered.
Connector to power amp not fitted correctly.
Input lead disconnected or damaged.
PROBLEM ON PHONO INPUT ONLY
No signal
Hum on Phono input.
Weak or Distorted signal.
WEAK BASS/ DIFFUSE STEREO IMAGE
Speakers connected to power amplifier wired out of phase.
REMOTE CONTROL NOT WORKING
Batteries flat, or incorrectly inserted.
IR transmitter or receiver windows obstructed.
GB
Check AC lead.
De-select Monitor mode.
Switch off Mute.
Check connections.
Consult dealer.
Center Balance control.
Check connections.
Check leads and connections.
Check MM-MC switch set correctly
Check phono earth lead is connected
Check the turntable is connected to the correct
MM or MC phono input
Check connections to all speakers in the system.
Check or replace batteries.
Remove obstruction.
NAD
7