Table of Contents
Advertisement
Automatic programming
If the previous setting from 1 to 5 is pressed in the
programming zone, the cooking time is reduced by one minute.
If the previous setting from 6 to 10 is pressed in the
programming zone, the cooking time is increased by one
minute.
Changing or cancelling the time
Select the hotplate and then press the
Change the cooking time using the programming zone or set
to
‹‹
in order to cancel the time.
Automatically switch off a hotplate with the deep-frying
function
When cooking using the deep-frying function, the programmed
cooking time begins to count down once the selected zone
reaches the desired temperature.
Once the time has elapsed
The hotplate switches off. A warning signal sounds. The time
program function lights up
When the
0
symbol is pressed, the indications turn off and the
beeping stops.
Cleaning lock function
Cleaning the control panel while the hob is switched on may
change the settings.
In order to avoid this, the hob has a cleaning lock function.
Press the
/
symbol. A signal sounds. The control panel is
‚
$
Automatic time limitation
If the hotplate remains in use for a long time and no changes
are made in the settings, the automatic time limitation function
is triggered.
The hotplate stops heating. The
heat indicator
/
flash alternately in the display.
œ
•
Displaying energy consumption
This function displays total energy consumption for the time the
hob has been switched on.
After switching off the hob, the consumption in kWh is
displayed for 10 seconds.
An example is shown in the image with a consumption
of
.
kWh.
‚
‹‰
12
0
symbol.
for 10 seconds in the display.
‹‹
"
,
‰
symbol and the residual
NZK
Notes
If cooking times have been programmed for various
■
hotplates, the time programming function always displays the
time for the selected hotplate.
Any cooking time can be programmed for up to 99 minutes.
■
The timer
The timer can be set for periods of up to 99 minutes. It is
independent of the other settings. This function does not
automatically switch off a hotplate.
Programming
Press the
0
symbol several times until the
1.
up.
‹‹
lights up in the time program function display.
Select the desired time in the programming panel.
2.
The timer starts to count down after a few seconds.
Changing or cancelling the time
Press the
0
symbol several times until the
up. Change the time with the programming zone, or set to
Once the time has elapsed
A warning signal sounds. In the time program function
display
is shown, and the
‹‹
10 seconds the indicators turn off.
When the
symbol is pressed, the indicators turn off and the
0
beeping stops.
locked for 35 seconds. The control panel surface can now be
cleaned without the risk of changing the settings.
Note: The lock does not affect the main switch. The hob may
be turned off when desired.
The indicator goes out when any symbol is pressed. The
hotplate can now be reset.
When the automatic time function is used, it is governed by the
selected power level (from 1 to 10 hours).
The Basic Settings chapter provides information on activating
this function.
W
indicator lights
W
indicator lights
indicator lights up. After
W
.
‹‹
Advertisement
Table of Contents
