Rear Panel - NAD T 572 Owner's Manual

Rear Panel

By connecting this DVD player to another NAD
audio component or system controller equipped
with a 12V trigger output, you can remotely operate
AC Power Cord
Plug into the power source.
Connect to digital (optical) audio equipment.
Connect to an amplifier, receiver or stereo system.
Dust protection cap
Remove the dust protection cap from the OPTICAL
DIGITAL OUT jack and connect the optical digital cable
(not supplied) securely so that the configurations of
both the cable and the connector match. Keep the dust
protection cap and always reattach the cap when not
using the connector to protect against dust intrusion.
Do not touch the inner pins of the jacks on the rear
panel. Electrostatic discharge may cause permanent
damage to the unit.
8
Select either S-VIDEO OUT or SCART's RGB signal,
depending on how you connected the DVD Player to the TV.
Connect to a TV with video inputs.
*System Select switch
12V TRIGGER IN
the T572 power ON/OFF.
OPTICAL (Digital audio out jack)
ANALOG AUDIO OUT (Left/Right)
Connect to a TV with SCART jack.
VIDEO OUTPUT Switch
S-VIDEO OUT
Connect to a TV with S-Video inputs.
VIDEO OUT
* System Select switch
You can enjoy NTSC or PAL discs by using System
Select switch to choose the appropriate system.
PAL:
NTSC: Select when DVD player is connected with
AUTO: Select when DVD player is connected with
• When the selected System Select switch does not
coincide with the system of your TV, normal color
picture may not be displayed.
• Set System Select switch when the power is turned
off.
TO TV (SCART) Jack
COAXIAL (Digital audio
out jack)
Connect to digital (coaxial)
audio equipment.
Select when DVD player is connected with
PAL-TV.
NTSC-TV.
Multi system TV.