Hyundai HYEA5080 User Manual page 6

1.4.9.3. Hand protection.
1.4.9.4. Protective
clothing.
1.4.9.5. Respiratoryprotective equipment should be used when in
an unventilated area.
1.4.9.6. When defueling always use a proprietyfuel retriever.
1.4.9.7. Always carry fuel in the correct and clearly marked container.
1.4.10 Additional safety.
1.4.10.6. Things to check before using your power auger.
1.4.10.6.1
for the shape of the land, and whether or not there are any
obstacles which might get in the way while working. Remove any
obstacles which can be cleared away before beginning work.
1.4.10.6.2
the power auger should be considered a hazardous area into which
no one should enter while the power auger is in use. When
necessary a yellow warning rope, warning signs, or some other form
of warnings should be placed around the perimeter of the area.
When work is to be performed simultaneously by two or more
persons, care should also be taken to constantly look around or
otherwise check for the presence and locations of other people
using power auger within the work area so as to maintain a distance
between each person sufficient to ensure safety.
1.4.10.6.3
power auger should be checked to make sure that it is in proper
working order and to make sure that there are no loose screws or
bolts, fuel leaks, ruptures, dents, or any other problems which
might interfere with safe operation. Be especially careful at this
time to check that there is nothing wrong with the drills or with the
joints by which the drills are attached to the power auger.
1.4.10.7 Things to check before starting the engine.
1.4.10.7.1 Take a careful look around to make sure that no obstacles exist
within a perimeter of 15 feet or less around the power auger before
starting the engine.
1.4.10.7.2 The power auger is equipped with a centrifugal clutch mechanism
which causes the drills to begin to rotate as soon as the engine is
started by putting the throttle into the start position. When
starting the engine, hold it firmly in place so as to ensure that nor
the throttle may not come into contact with any obstacles when
the engine starts up.
1.4.10.7.3 Never place the throttle into the high speed position when starting
the engine.
1.4.10.7.4 After starting up the engine, check to make sure that the drills stop
rotating when the throttle is moved fully back to its original position.
Before beginning work, look around carefully to get a feel
The area within a perimeter of 45 feet of the person using
Before beginning work, each component of the
Page 6