Before Calling Service Personnel - NAD L55 Owner's Manual

Reference

BEFORE CALLING SERVICE PERSONNEL

SYMPTOMS AND CORRECTION
Check the following guide for the possible cause of a problem before contacting service.
No power
The power is on, but the DVD player does
not work.
No picture
No sound
The playback picture is poor
The DVD player does not start playback
GB
The remote control does not work
properly.
40
SYMPTOM
• The power cord is disconnected
• No disc is inserted.
• The TV is not set to receive DVD signal
• The video cable is not connected securely.
• The connected TV power is turned off.
• The equipment connected with the audio
• The audio cables are not connected
• The power of the equipment connected
• The Digital Audio Output is set to the
• The disc is dirty.
• No disc is inserted.
• An unplayable disc is inserted.
• The disc is placed upside down.
• The disc is not placed within the guide.
• The disc is dirty.
• A menu is on the TV screen.
• The Rating level is set.
• The remote control is not pointed at the
• The remote control is too far from the
• There is an obstacle in the path of the
• The batteries in the remote control are
CAUSE
output.
cable is not set to receive DVD signal
output.
securely.
with the audio cable is turned off.
wrong position.
remote sensor of the DVD player.
DVD player.
remote control and the DVD player.
exhausted.
CORRECTION
• Plug the power cord into the wall outlet
securely.
• Insert a disc (Check that the DVD or, audio
CD indicator in the DVD display is lit).
• Select the appropriate video input mode
on the TV so that the picture from the
DVD player appears on the TV screen.
• Connect the video cable into the jacks
securely.
• Turn on the TV.
• Select the correct input mode of the audio
receiver so you can listen to the sound
from the DVD player.
• Connect the audio cable into the jacks
securely.
• Turn on the equipment connected with the
audio cable.
• Set the Digital Audio Output to the correct
position, then turn on the DVD player
again by pressing the POWER button.
• Clean the disc.
• Insert a disc (Check that the DVD, or audio
CD indicator in the DVD display is lit).
• Insert a playable disc (Check the disc type,
color system and Regional code).
• Place the disc with the playback side
down.
• Place the disc on the disc tray correctly
inside the guide.
• Clean the disc.
• Press the SETUP button to turn off the
menu screen.
• Cancel the Rating function or change the
rating level.
• Point the remote control at the remote
sensor of the DVD player.
• Operate the remote control within about
23 ft (7 m).
• Remove the obstacle.
• Replace the batteries with new ones.