Start Button - Candy GO 4 1064 D User Instructions

DESCRIPTION OF CONTROL
DOOR HANDLE
Press the finger-bar insi
IMPORTANT!
A special safety device prevents the door from opening at the end of
the wash/spin cycle. At the end of the spin phase wait up to 2 min-
utes before opening the door.
DOOR LOCKED INDICATOR
The "Door Locked" indicator light is illuminated when the door is fully closed and the
machine is ON.
"START/PAUSE"
When
will flash momentarily and then illuminate.
If the door is not closed the indicator will continue to flash.
A special safety device prevents the door from being opened immediately after the end
of the cycle.
Wait for 2 minutes after the wash cycle has finished and the Door Locked light has gone
out before opening the door. At the end of cycle turn the program selector to OFF.

START BUTTON

Press to start the selected cycle.
NOTE: When the start button has been pressed, the appliance can
take few seconds before starts working.
CHANGING THE SETTINGS AFTER THE PROGRAMMES HAS STARTED
(PAUSE)
Press and hold the "START/PA
lights on the options button
machine has been paused,
button again to cancel the
If you wish to add or remove
safety device unlocks the do
When you have ca rried out the manoeuvre, close the door, press
"START/PAUSE" butt
off.
CANCELLING THE PROGRAMME
To cancel the program:
• Set the selector to the "OFF" position.
•
Select a different program.
•
Re-set the program s elector to the "OFF" position.
de the door handle to open the door.
is pressed on the machine with the door closed the indicator
USE" button for about 2 seconds, the flashing
s and time remaining indicator will show that the
adjust as required and press the "START/PAUSE"
flashing lights.
items during washing, wait 2 minutes until the
or.
on and the appliance will continue working where it left
47