Volkswagen Golf 2013 Workshop Manual page 124

Golf 2013 ➤
7-speed dual clutch gearbox 0CW - Edition 10.2012
Preparing output shaft bearing race 1 for pressing in
– First place tube -VW 415 A- under bearing seat.
This illustration show view »from below«. This means press pres‐
sure is not applied to clutch housing in an uncontrolled manner,
but is absorbed by tube.
Pressing in output shaft bearing race 1
– Insert determined shim if you already know its thickness.
Pulling out output shaft bearing race 2 and 3
There is 1 shim under bearing.
Note
It may be that oil deflectors get in the way when internal puller is
being put on. Then carefully knock down guide plates using a
hammer. Plates deformed in this way must be renewed during
installation.
120
Rep. gr.34 - Controls, housing