Subscribe to Our Youtube Channel
Related Manuals for Conrad-johnson design PREMIER SIX
Summary of Contents for Conrad-johnson design PREMIER SIX
- Page 1 OWNER'S MANUAL PREMIER SIX VACUUM TUBE PRE-PREAMPLIFIER conrad-johnson design, inc. 703-698-8581...
- Page 2 To fully realize the performance potential of your Premier Six it is important that you install it in accordance with the instructions provided here.
- Page 3 LIMITED WARRANTY FOR THE conrad-johnson PREMIER SIX 1. conrad-johnson design, inc. warrants to the original purchaser that the conrad- johnson Premier Six will perform to specifications as published in the owner's manual and that it will be free of defects in materials and workmanship for a period of three years from the date of original purchase.
-
Page 4: Circuit Design
RF applications where low noise and wide bandpass are of critical importance. The Premier Six uses one nuvistor per channel as a simple triode amplifier which is direct coupled to a cathode follower output stage for low output impedance. -
Page 5: Installation
The audio cables from your turntable should be connected to the lower pair of phono jacks (labeled Inputs) on the back of the Premier Six. The ground wire from the turntable should be attached to the Premier Six binding post. Connect the upper pair of phono jacks (labeled Outputs) to the phono input of your preamplifier. -
Page 6: Absolute Phase
ABSOLUTE PHASE Musical transients are positive going - that is they first create a pressure front in the surrounding air. It is important that your stereo system reproduces transients in the same way since the ear can distinguish between positive and negative transients. This means that on a transient the speaker diaphragms should first move toward the listener - creating a pressure front. - Page 7 Accordingly, you should always turn your Premier Six off when not in use to preserve the tubes. When your Premier Six becomes noisy, merely replace the tubes. Replacement sets are available from your conrad-johnson dealer or...
-
Page 8: Specifications
SPECIFICATIONS Input Impedance: 2000 ohms Output Impedance: Less than 200 ohms Voltage Gain: 28 db Maximum Output: Greater than 5.0 volts into 50K load Input Overload: Greater than 200 mv. Total Harmonic Distortion: Less than .05% at 100 mv. Bandwidth: 5 Hz to 100 kHz Frequency Response: 20 Hz to 20 kHz +/- .1 db Tube Complement: 4 6CW4 Dimensions:... - Page 9 SERVICE In the event your Premier Six pre-preamplifier requires service, repack it with the original packing material and ship freight charges prepaid via United Parcel Service (UPS) to: conrad-johnson design, inc. 2733 Merrilee Drive Fairfax, VA 22031 Be sure to enclose a note explaining the problem you are having in as much detail as possible.
Need help?
Do you have a question about the PREMIER SIX and is the answer not in the manual?
Questions and answers