Hour Meter; Tracking Knob; Hydro Release Levers - Husqvarna EZ24T Operator's Manual

Hour Meter

the hour meter displays the total operating time.
It will flash CHG OIl (Change Oil) at 50 hour intervals.
the flash duration is one hour before and one hour
after the interval. the CHG OIl icon will come on
and shut off automatically. the hour meter cannot be
manually reset.

Tracking Knob

If the mower is not tracking straight, check the tire
air pressures. Recommended air pressure is 15 psi
(103 kPa / 1 bar) for all tires. tracking must be
checked on a flat and level concrete or blacktop
surface.
Rotating the tracking knob allows fine tuning
adjustments so the machine tracks straight with the
steering control levers in the full forward position.
Rotate the knob clockwise (as viewed from the
operation position) to increase the speed on the left
lever. Rotate counter clockwise to decrease speed.

Hydro Release Levers

transaxle bypass linkages must be engaged when
pushing or pulling the mower. the release levers are
located on each side of the rear of the unit below the
rear engine plate. See Moving Machine By Hand in
the Operation section.
COntROlS
Hour meter
Tracking knob
Release lever - left side
8052-001
8058-020
8058-147
23
Husqvarna-