Sony SRX-R515P Manual page 5

Bulletin No.: 036
SRX-R515P
Configuring Storage Server IP Addresses
The storage server or PC that you wish to connect to the R515 will require an IP address on
the same subnet as the CTRL Port to access the GUI, and an IP address on the same
subnet as the DATA port for the server to be seen as a DCP/KDM source.
This can be achieved in two ways either give separate IPs to two NICs on the server, or
configure one NIC with two IP addresses. Below is the procedure to configure one NIC with
two IP addresses on Windows Server 2008 R2.
Configuring two IP addresses on Windows Server 2008
Log on to the server/PC you wish to access the R515 from.
Go to Start Menu > Control Panel > Network and Sharing Centre > Network Adapters.
Right Click on the Network adapter and select Properties > Internet Protocol Version 4
properties.
The following screen will appear.
Select 'Use the following IP Address' and enter an IP in the CTRL in Subnet range. Since
the CRTL in IP is 192.168.101.111 this was chosen as 192.168.101.5.
To add a second IP address to the NIC click the 'Advanced' button, then click add to the IP
address section. Since the DATA in IP is 192.168.201.111 this was chosen as
192.168.201.5.
Login and navigate to
Figure 5 IP4 properties
DCinema Bulletin Archive:
https://filex.sony-europe.com/
Dealers/Digital Cinema Bulletins
th
19 February, 2013
folder