Kenwood FP905 Manual page 9

hints
G
Use fresh ingredients
G
Don't cut food too small. Fill the width of the large feed tube
fairly full. This prevents the food from slipping sideways during
processing. Alternatively use the small feed tube.
G
When using the chipper disc, place ingredients horizontally.
G
When slicing or shredding: food placed upright
shorter than food placed horizontally
G
There will always be a small amount of waste on the plate or in
the bowl after processing.
m u
lt i
p ro
citrus press
Use the citrus press to squeeze
the juice from citrus fruits (eg
oranges, lemons, limes and
grapefruits).
cone
sieve
to use the citrus
press
1 Fit the drive shaft and bowl
onto the power unit.
2 Fit the sieve into the bowl -
ensuring the sieve handle is
locked into position directly over
the bowl handle .
3 Place the cone over the drive
shaft turning until it drops all the way down
4 Cut the fruit in half. Then switch on and press the fruit onto the
cone.
G
The citrus press will not operate if the sieve is not
locked correctly.
comes out
.
m u
lt i
p ro
m u
lt i
p r
o
.
mill
Use the mill for milling herbs, nuts and
coffee beans.
blade unit
sealing ring
jar
sprinkler lid
safety
G
Never fit the blade unit to your machine
without the jar fitted.
G
Never unscrew the jar while the mill is fitted to
your machine.
G
Don't touch the sharp blades. Keep the
blade unit away from children.
G
Never remove the mill until the blades have
completely stopped.
Note: The mill base in not
interchangeable with the FP920 glass
liquidiser jug. The processor will not
operate if the wrong base is fitted.
Refer to graphics on blade unit bases.
important
G
To ensure long life of your mill, never run for
longer than 30 seconds. Switch off as soon as
you've got the right consistency.
G
Don't process spices - they may damage the plastic.
G
The machine won't work if the mill is fitted incorrectly.
G
Use for dry ingredients only.
to use your mill
1 Put your ingredients into the jar. Fill
it no more than half full.
2 Fit the sealing ring into the blade
unit.
3 Turn the blade unit upside down.
Lower it into the jar, blades down.
4 Screw the blade unit onto the jar
until it is finger tight.
5 Place the mill onto the power unit
and turn to lock .
6 Switch on to maximum speed or
use the pulse control.
7 After milling, you can replace the blade unit with the sprinkler lid
and shake out your food.
G
The sprinkler lid is not airtight.
hints
G
Herbs are best milled when clean and dry.
6
m u
lt i
p ro