Connections To Your Amplifier - Yamaha NS-F901 Owner's Manual

Hide thumbs Also See for NS-F901:

Owner's manual (9 pages)

Owner's manual (41 pages)

Table Of Contents

Table of Contents

Available languages

This speaker system is capable of standard connections and bi-wired connections. Before making

connections, make sure that the amplifier is switched off.

■ CONNECTIONS

You need a commercially available speaker cable.

The size and/or material of a speaker cable affects on the

sound quality. Therefore, we recommend you to purchase

a high-quality speaker cable to exert the performance of

this unit.

Notes

• Connect the (+) terminals on the amplifier and the

speakers using one side of the cable. Connect the

(–) terminals on both components using the other

side of the cable.

• Connect one speaker to the left (L) terminals of

your amplifier, and another speaker to the right (R)

terminals, making sure not to reverse the polarity

(+, –). If one speaker is connected with reversed

polarity, the sound will be unnatural and lack bass.

• When using an amplifier with a rated output

power higher than the nominal input power of the

speaker, care should be taken never to exceed the

speaker's maximum input.

• The speaker may be damaged if certain sounds

are continuously output at high volume level.

For example, if sine waves from a test disc, bass

sounds from electronic instruments, etc., are

continuously output, or when the stylus of a

turntable touches the surface of a disc, reduce the

volume level to prevent the speaker from being

damaged.

• Please refer to the owner's manual that came with

your amplifier or receiver.

How to connect the cables:

Loosen the knob.

R emove 15 mm (5/8") of insulation from each end of

the cables, and twist the exposed conductors together

neatly and tightly, as shown below.

15 mm

(5/8")

I nsert the bare wire into the hole.

T ighten the knob and secure the cables.

T est the firmness of the connection by pulling lightly on

the cables at the terminal.

Notes

• Do not let the bare speaker wires touch each other

as this could damage the speaker or the amplifier,

or both of them.

• Do not insert the insulation coating into the hole.

The sound may not be produced.