Servo Installation - E-FLITE Enticement F3P Assembly Manual

Servo Installation

Required Parts
Airframe assembly
Rudder control horn support
1/16 x 13/16-inch (2mm x 20mm) carbon control horn (4)
4-inch (103mm) carbon pushrods (2)
14 7 -inch (370mm) carbon pushrod (1)
/
16
15 5 -inch (398mm) carbon pushrod (1)
/
8
Plywood pushrod supports (4)
Required Tools and Adhesives
Foam-safe CA
Low-temperature hot glue
Soldering iron
E-flite Enticememt F3P Profile Assembly Manual
Control horn support (3)
Heat-shrink tubing (4)
Foam-safe CA activator
Hot glue gun
Hobby knife
1. Use a ruler to measure 9/16-inch (15mm) on each

of the four 1/16 x 13/16-inch (2mm x 20mm) carbon
control horns. Use foam-safe CA to glue each of the
control horn supports to the rods with the bottom edge
of the support 9/16-inch (15mm) from the top of the
control horn.
Note: The rudder control horn support is longer than the
aileron and elevator supports. This longer edge faces
away from the control horn as shown in the photo.
15