Rudder And Elevator Servo Installation - E-FLITE Stearman PT-17 15e ARF Assembly Manual

Rudder and Elevator Servo Installation

Parts Required
Fuselage assembly Mini servos with hardware (2)
Radio system JR MatchMaker
Tools Required
Pin vise 1/16-inch drill bit
Sidecutters Thin CA
Felt-tipped pen Philips screwdriver #0
Ο 1. Remove the cockpit hatch by lifting at the rear then
pulling aft to disengage the tabs at the forward
end. Set the hatch aside.
4 4
Ο 2. Install the grommets and bushings in the rudder
and elevator servos. Note that the bushing is
installed from the bottom of the mounting lugs.
Ο 3. Center the servos using your radio or a JR
MatchMaker. Using sidecutters, remove three of
the arms from each standard servo horn,
leaving one long arm on each as shown.
Ο 4. Place the rudder and elevator servos in the
fuselage servo cutouts and mark the mounting
holes with a felt-tipped pen.
Ο 5. Remove the servos. Use a 1/16-inch drill bit
in a pin vise to drill the mounting holes.
E-flite Stearman PT-17 15e ARF Assembly Manual